UnForm is designed to work as a filter, accepting standard text input from your
application's print runs, analyzing the text, and adding enhancements and process
control while sending the job out to the printer. Typically, this output is routed
through spooling software such as
EasySpooler.
A typical interface to a printer via EasySpooler would use the "llp" spooling
command, like this:
|uf60c -f <rulefile> | llp -odatat=c -d<printername>
If the destination is a lpr printer, then a filter code can be used to turn off filtering at the server end:
|uf60c -f <rulefile> | llp -Fl -d<printername>
The purpose of the -odatat=c and -Fl (that's -F and the letter "ell")
options is to force pass-through processing of UnForm's output. The -odatat=c
option specifies PCL output. An alternative is to specify binary output with
-odatat=b, although EasySpooler is then unable to count pages and therefore can't
provide page control features, such as restarting a job at a particular page.
UnForm and CirrusPrint are registered trademarks of SDSI. General and
MailCall are trademarks of SDSI. Other product names
used herein may be trademarks or registered trademarks of their respective
owners.
SDSI uses Google analytics and conversion tracking on some site pages.
Site design by ZiMDesign.
